press-through die

Design of Side Hold Punching Die for the Fixed Frame in Automobile Steering System Design of Press Slope Die for Pressing Cage of New Type Spherical Roller Bearings

汽车转向系统中固定架冲侧孔模具设计新型球面滚子轴承冲压保持架压坡模的设计

Dowels must be press fit in die shoes and strippers, and push fit in die sections.

在摸座及脱料板上的合销必须为压配合,在摸板上的为推配合.

Give the button a slight press and the music would die.

把按钮轻轻一按,音乐就会停止.

A hydraulic lifter driven by pneumatic for quick die change in heavy-duty press was introduced.

介绍了一种用于大型压力机模具快速更换系统的气动液压举升装置。

Design of Quick Die Change System for Heavy-duty Press

大型压力机的快速换模系统设计

The die contacting press is the special equipment of automobile die.

模具研配液压机是研配汽车模具的专用设备.

Research on Gap of Roll-die of Pellets Plane-die Press Computerized 3-D Design Method for Guide Shoe of Cone Type Rotary Reeling Mill

三锥辊式平模制粒机模辊间隙的探讨锥形辊斜轧均整机导板的计算机三维设计方法

Design of quick die change system of heavy-duty press has been introduced with principle and component of lifter, pump and control valve of pneumatic and hydraulic, emphasis especially on design and calculation for lifter and pump.

介绍了用于大型压力机的模具快速更换系统的组成及工作原理，举升器和气动液压泵的结构与工作原理，举升器控制系统的原理等，并重点介绍了举升器和气动液压泵的设计计算。

Compressed air is used as the drive of the die and the die can work without a press, which reduces the investment in equipment.

模具利用压缩气体为动力，不需压力机就能工作，减少了设备的投资。

This paper introduced the method of bending metal tubes by die on hydraulic press.

介绍了金属管件在液压机上用模具弯曲成形的特点及优缺点.